Datasheet

MC68HC912DT128A — Rev 4.0 Technical Data
MOTOROLA Resource Mapping 87
Technical Data — MC68HC912DT128A
Section 6. Resource Mapping
6.1 Contents
6.2 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .87
6.3 Internal Resource Mapping. . . . . . . . . . . . . . . . . . . . . . . . . . . .87
6.4 Flash EEPROM mapping through internal Memory Expansion 92
6.5 Miscellaneous System Control Register . . . . . . . . . . . . . . . . . .96
6.6 Mapping test registers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .99
6.7 Memory Maps . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .100
6.2 Introduction
After reset, most system resources can be mapped to other addresses
by writing to the appropriate control registers.
6.3 Internal Resource Mapping
The internal register block, RAM, and EEPROM have default locations
within the 64K byte standard address space but may be reassigned to
other locations during program execution by setting bits in mapping
registers INITRG, INITRM, and INITEE. During normal operating modes
these registers can be written once. It is advisable to explicitly establish
these resource locations during the initialization phase of program
execution, even if default values are chosen, in order to protect the
registers from inadvertent modification later.
Writes to the mapping registers go into effect between the cycle that
follows the write and the cycle after that. To assure that there are no
Frees
cale Semiconductor,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
nc...