Datasheet

Chapter 8 Internal Clock Generator (S08ICGV4)
MC9S08AW60 Data Sheet, Rev 2
Freescale Semiconductor 133
8.1.3 Block Diagram
Figure 8-3 is a top-level diagram that shows the functional organization of the internal clock generation
(ICG) module. This section includes a general description and a feature list.
Figure 8-3. ICG Block Diagram
8.2 External Signal Description
The oscillator pins are used to provide an external clock source for the MCU. The oscillator pins are gain
controlled in low-power mode (default). Oscillator amplitudes in low-power mode are limited to
approximately 1 V, peak-to-peak.
8.2.1 EXTAL — External Reference Clock / Oscillator Input
If upon the first write to ICGC1, either the FEE mode or FBE mode is selected, this pin functions as either
the external clock input or the input of the oscillator circuit as determined by REFS. If upon the first write
to ICGC1, either the FEI mode or SCM mode is selected, this pin is not used by the ICG.
8.2.2 XTAL — Oscillator Output
If upon the first write to ICGC1, either the FEE mode or FBE mode is selected, this pin functions as the
output of the oscillator circuit. If upon the first write to ICGC1, either the FEI mode or SCM mode is
OSCILLATOR (OSC)
FREQUENCY
INTERNAL
EXTAL
XTAL
REFERENCE
GENERATORS
CLOCK
SELECT
8 MHz
IRG
LOSS OF LOCK
AND CLOCK DETECTOR
LOCKED
LOOP (FLL)
FIXED
CLOCK
SELECT
ICGOUT
TYP 243 kHz
RG
ICGLCLK
ICG
FFE
V
DDA
V
SSA
(SEE NOTE 2)
(SEE NOTE 2)
DCO
WITH EXTERNAL REF
SELECT
REF
SELECT
LOCAL CLOCK FOR OPTIONAL USE WITH BDC
OUTPUT
CLOCK
SELECT
ICGDCLK
/R
ICGERCLK
ICGIRCLK
NOTES:
1. See Table 8-9 for specific use of ICGOUT, FFE, ICGLCLK, ICGERCLK
2. Not all HCS08 microcontrollers have unique supply pins for the ICG. See the device pin assignments.