Datasheet

Chapter 2 Pins and Connections
MC9S08DZ128 Series Data Sheet, Rev. 1
Freescale Semiconductor 37
89 57
43
V
REFH
90 58 V
DDA
91 — — PTK4
92 — — PTK5
93 — — PTK6
94 — — PTK7
95 59 44 PTA4 PIA4 ADP4
96 60 45 PTB4 PIB4 ADP12
97 61 — PTC4 ADP20
98 62 46 PTA5 PIA5 ADP5
99 63 47 PTB5 PIB5 ADP13
100 64 48 PTA6 PIA6 ADP6
1
Pin does not contain a clamp diode to V
DD
and should not be driven above
V
DD
. The voltage measured on this pin when internal pull-up is enabled may
be as low as V
DD
- 0.7V. The internal gates connected to this pin are pulled to
V
DD
.
2
The IIC1 module pins can be repositioned using IIC1PS bit in the SOPT1
register. The default reset locations are on PTF2 and PTF3.
3
The SCI2 module pins can be repositioned using SCI2PS bit in the SOPT1
register. The default reset locations are on PTF0 and PTF1.
4
If both these analog modules are enabled they both will have access to the pin.
Table 2-1. Pin Availability by Package Pin-Count (continued)
Pin Number <-- Lowest Priority --> Highest
100 64 48
Port
Pin/Interrupt
Alt 1 Alt 2