Datasheet

Appendix A Electrical Characteristics
MC9S08DZ128 Series Data Sheet, Rev. 1
428 Freescale Semiconductor
Figure A-5. Typical Run I
DD
vs. Bus Frequency (V
DD
= 5V)
8 P Adder to stop3 for oscillator enabled
7
(EREFSTEN =1)
S3I
DDOSC
55 8
μA
P358
1
Typical are measured at 25°C. See Figure A-8 through Figure A-10 for typical curves across
voltage/temperature.
2
Max values in this column apply for the full operating temperature range of the device unless otherwise
noted.
3
All modules except ADC active, ICS configured for FBE, and does not include any dc loads on port pins
4
All modules except ADC active, ICS configured for FEI, and does not include any dc loads on port pins
5
Stop currents are tested in production for 25°C on all parts. Tests at other temperatures depend upon the
part number suffix and maturity of the product. Freescale may eliminate a test insertion at a particular
temperature from the production test flow once sufficient data has been collected and approved.
6
Most customers are expected to find that auto-wakeup from stop2 or stop3 can be used instead of the
higher current wait mode.
7
Values given under the following conditions: low range operation (RANGE = 0) with a 32.768kHz crystal
and low power mode (HGO = 0).
Table A-7. Supply Current Characteristics (continued)
Num C Parameter Symbol
V
DD
(V)
Typ
1
Max
2
Unit
Run I
DD
(mA)
f
bus
(MHz)
8421016
0
2
4
10
20
14
FEI (low range DCO)
FBE
12
6
8
18
16
PEI or FEI (mid range DCO)