Datasheet

Electrical Characteristics
MC9S08GT16A/GT8A Data Sheet, Rev. 1
Freescale Semiconductor 267
Stop3 mode supply current
S3I
DD
3 675 nA
4.3 µA
(4)
7.2 µA
(4)
17.0 µA
(5)
45 µA
(5)
55
70
85
125
2 500 nA
3.5 µA
(4)
6.2 µA
(4)
15.0 µA
(4)
40 µA
(4)
55
70
85
125
RTI adder to stop2 or stop3
6
3 300 nA
2 300 nA
LVI adder to stop3
(LVDSE = LVDE = 1)
370µA
260µA
Adder to stop3 for oscillator enabled
7
(OSCSTEN =1)
35µA
25µA
Adder for loss-of-clock enabled
(LOCD=0)
39µA
29µA
Adder for high gain oscillator enabled
(HGO=1)
328µA
22µA
1
Typicals are measured at 25°C. See Table A-6 through Table A-9 for typical curves across voltage/temperature.
2
Values given here are preliminary estimates prior to completing characterization.
3
All modules except ATD active, ICG configured for FBE, and does not include any dc loads on port pins
4
Values are characterized but not tested on every part.
5
Every unit tested to this parameter. All other values in the Max column are guaranteed by characterization.
6
Most customers are expected to find that auto-wakeup from stop2 or stop3 can be used instead of the higher current wait mode.
Wait mode typical is 560 µA at 3 V and 422 µA at 2V with f
Bus
= 1 MHz.
7
Values given under the following conditions: low range operation (RANGE = 0), low power mode (HGO = 0), clock monitor
disabled (LOCD = 1).
Table A-7. Supply Current Characteristics (continued)
Parameter Symbol V
DD
(V) Typical
1
Max
2
Temp. (°C)