Datasheet

Appendix A Electrical Characteristics
MC9S08GB60A Data Sheet, Rev. 2
Freescale Semiconductor 263
A.4 Electrostatic Discharge (ESD) Protection Characteristics
Although damage from static discharge is much less common on these devices than on early CMOS
circuits, normal handling precautions should be used to avoid exposure to static discharge. Qualification
tests are performed to ensure that these devices can withstand exposure to reasonable levels of static
without suffering any permanent damage. All ESD testing is in conformity with CDF-AEC-Q00 Stress
Test Qualification for Automotive Grade Integrated Circuits. (http://www.aecouncil.com/) This device
was qualified to AEC-Q100 Rev E. A device is considered to have failed if, after exposure to ESD pulses,
the device no longer meets the device specification requirements. Complete dc parametric and functional
testing is performed per the applicable device specification at room temperature followed by hot
temperature, unless specified otherwise in the device specification.
A.5 DC Characteristics
This section includes information about power supply requirements, I/O pin characteristics, and power
supply current in various operating modes.
Table A-3. ESD Protection Characteristics
Parameter Symbol Value Unit
ESD Target for Machine Model (MM)
MM circuit description
V
THMM
200 V
ESD Target for Human Body Model (HBM)
HBM circuit description
V
THHBM
2000 V
Table A-4. DC Characteristics (Sheet 1 of 3)
(Temperature Range = –40 to 85°C Ambient)
Parameter Symbol Min Typical
1
Max Unit
Supply voltage (run, wait and stop modes.)
0 < f
Bus
< 8 MHz
0 < f
Bus
< 20 MHz
V
DD
1.8
2.08
3.6
3.6
V
Minimum RAM retention supply voltage
applied to
V
DD
V
RAM
1.0
2
—V
Low-voltage detection threshold — high range
(V
DD
falling)
(V
DD
rising)
V
LVDH
2.08
2.16
2.1
2.19
2.2
2.27
V
Low-voltage detection threshold — low range
(V
DD
falling)
(V
DD
rising)
V
LVDL
1.80
1.88
1.82
1.90
1.91
1.99
V
Low-voltage warning threshold — high range
(V
DD
falling)
(V
DD
rising)
V
LVW H
2.35
2.35
2.40
2.40
2.5
2.5
V