Datasheet

Freescale Semiconductor
Data Sheet: Technical Data
Document Number: MC9S08JS16
Rev. 4, 4/2009
© Freescale Semiconductor, Inc., 2008-2009. All rights reserved.
This document contains information on a product under development. Freescale reserves the
right to change or discontinue this product without notice.
MC9S08JS16
Features:
• 8-Bit HCS08 Central Processor Unit (CPU)
– 48 MHz HCS08 CPU (central processor unit)
– 24 MHz internal bus frequency
– Support for up to 32 interrupt/reset sources
• Memory Options
– Up to 16 KB of on-chip in-circuit programmable flash
memory with block protection and security options
– Up to 512 bytes of on-chip RAM
– 256 bytes of USB RAM
• Clock Source Options
– Clock source options include crystal, resonator, external
clock
– MCG (multi-purpose clock generator) — PLL and FLL;
internal reference clock with trim adjustment
• System Protection
– Optional computer operating properly (COP) reset with
option to run from independent 1 kHz internal clock
source or the bus clock
– Low-voltage detection
– Illegal opcode detection with reset
– Illegal address detection with reset
• Power-Saving Modes
– Wait plus two stops
• USB Bootload
– Mass erase entire flash array
– Partial erase flash array — erase all flash blocks except
for the first 1 KB of flash
– Program flash
• Peripherals
– USB — USB 2.0 full-speed (12 Mbps) with dedicated
on-chip 3.3 V regulator and transceiver; supports
endpoint 0 and up to 6 additional endpoints
– SPI — One 8- or 16-bit selectable serial peripheral
interface module with a receive data buffer hardware
match function
– SCI — One serial communications interface module
with optional 13 bit break. Full duplex non-return to zero
(NRZ); LIN master extended break generation; LIN
slave extended break detection; wakeup on active edge
– MTIM — One 8-bit modulo counter with 8-bit prescaler
and overflow interrupt
– TPM — One 2-channel 16-bit timer/pulse-width
modulator (TPM) module; selectable input capture,
output compare, and edge-aligned PWM capability on
each channel; timer module may be configured for
buffered, centered PWM (CPWM) on all channels
– KBI — 8-pin keyboard interrupt module
– RTC — Real-time counter with binary- or
decimal-based prescaler
– CRC — Hardware CRC generator circuit using 16-bit
shift register; CRC16-CCITT compliancy with
x
16
+x
12
+x
5
+1 polynomial
• Input/Output
– Software selectable pullups on ports when used as inputs
– Software selectable slew rate control on ports when used
as outputs
– Software selectable drive strength on ports when used as
outputs
– Master reset pin and power-on reset (POR)
– Internal pullup on RESET
, IRQ, and BKGD/MS pins to
reduce customer system cost
• Package Options
– 24-pin quad flat no-lead (QFN)
– 20-pin small outline IC package (SOIC)
MC9S08JS16 Series
Covers:
MC9S08JS16
MC9S08JS8
MC9S08JS16L
MC9S08JS8L
20 W-SOIC
Case 751D
24 QFN
Case 1982-01
TBD