Datasheet

Appendix A Electrical Characteristics
MC9S08LC60 Series Data Sheet: Technical Data, Rev. 4
Freescale Semiconductor 331
Figure A-6. Typical Run I
DD
for FBE FEE Mode, I
DD
vs. V
DD
Adder to stop3 for oscillator enabled
(6)
(OSCSTEN =1) (32 kHz)
34μA85
2 3.5 μA85
Adder for loss-of-clock detection
(LOCD = 0)
39μA85
1
Typicals are measured at 25°C. See Table A-6 through Table A-9 for typical curves across voltage/temperature.
2
Values given here are preliminary estimates prior to completing characterization.
3
All modules except ADC active, ICG configured for FBE, and does not include any dc loads on port pins.
4
With LCD and external clock module disabled.
5
Most customers are expected to find that auto-wakeup from stop2 or stop3 can be used instead of the higher current wait
mode. Wait mode typical is 560 μA at 3 V and 422 μA at 2V with f
Bus
= 1 MHz.
6
Values given under the following conditions: low range operation (RANGE = 0), low power mode (HGO = 0), clock monitor
disabled (LOCD = 1).
Table A-6. Supply Current Characteristics (continued)
Parameter Symbol V
DD
(V) Typical
(1)
Max
(2)
Temp. (°C)