Datasheet

Appendix A Electrical Characteristics
MC9S08QG8 and MC9S08QG4 Data Sheet, Rev. 5
Freescale Semiconductor 273
Figure A-6. Typical Run I
DD
for FBE and FEE, I
DD
vs. V
DD
(ACMP and ADC off, All Other Modules Enabled)
RTI adder to stop1, stop2 or stop3
4
—
3 300 nA — 85
2 300 nA — 85
LVD adder to stop3 (LVDE = LVDSE = 1) —
3 70 μA— 85
2 60 μA— 85
Adder to stop3 for oscillator enabled
5
(EREFSTEN =1)
—
35 μA— 85
24 μA— 85
1
3-V values are 100% tested; 2-V values are characterized but not tested.
2
Typicals are measured at 25°C.
3
Does not include any DC loads on port pins.
4
Most customers are expected to find that auto-wakeup from a stop mode can be used instead of the higher current wait mode.
5
Values given under the following conditions: low range operation (RANGE = 0), Loss-of-clock disabled (LOCD = 1), low-power
oscillator (HGO = 0).
Table A-7. Supply Current Characteristics
Parameter Symbol V
DD
(V)
1
Typical
2
Max T (°C)
V
DD
(V)
I
DD
(mA)
4
3
2
1
0
1.8 2.1 2.4
2.7
33.33.6
FBE 2-MHz Crystal, 1-MHz Bus
FEE 32-kHz Crystal, 1-MHz Bus
FEE 2-MHz Crystal, 8-MHz Bus