Datasheet

Appendix A Electrical Characteristics
MC9S08SH8 MCU Series Data Sheet, Rev. 3
Freescale Semiconductor 299
Figure A-5. Typical Run I
DD
vs. Bus Frequency (V
DD
= 5V)
1
Typical values are based on characterization data at 25°C. See Figure A-5 through Figure A-7 for typical curves
across voltage/temperature.
2
Max values in this column apply for the full operating temperature range of the device unless otherwise noted.
3
All modules except ADC active, ICS configured for FBE, and does not include any dc loads on port pins.
4
All modules except ADC active, ICS configured for FEI, and does not include any dc loads on port pins.
5
Stop currents are tested in production for 25°C on all parts. Tests at other temperatures depend upon the part
number suffix and maturity of the product. Freescale may eliminate a test insertion at a particular temperature
from the production test flow once sufficient data has been collected and is approved.
6
Most customers are expected to find that auto-wakeup from stop2 or stop3 can be used instead of the higher
current wait mode.
7
Values given under the following conditions: low range operation (RANGE = 0) with a 32.768kHz crystal and low
power mode (HGO = 0).
Run I
DD
(mA)
f
bus
(MHz)
8421016
0
2
4
10
20
6
8
FEI
FBELP