Datasheet

Appendix A Electrical Characteristics
MC9S08EL32 Series and MC9S08SL16 Series Data Sheet, Rev. 3
Freescale Semiconductor 339
5
Stop2 mode supply current
C–40°C (C,M, & V suffix) 0.9 –
P25°C (All parts) 0.9 –
P
5
85°C (C suffix only) 5 5.0 40.0 μA
P
5
105°C (V suffix only) 11.0 50.0
P
5
125°C (M suffix only) S2I
DD
29.1 65.0
C–40°C (C,M, & V suffix) 0.9 –
P25°C (All parts) 0.9 –
P
5
85°C (C suffix only) 3 4.2 35.0 μA
P
5
105°C (V suffix only) 8.8 45.0
P
5
125°C (M suffix only) 25 60.0
6
C RTC adder to stop2 or stop3
6
S23I
DDRTI
5300500nA
3300500nA
7
C LVD adder to stop3 (LVDE = LVDSE = 1) S3I
DDLVD
5110180μA
390160μA
8
C Adder to stop3 for oscillator enabled
7
(EREFSTEN =1)
S3I
DDOSC
5,3 5 8 μA
1
Typical values for specs 1, 2, 3, 6, 7, and 8 are based on characterization data at 25°C. See Figure A-5
through Figure A-7 for typical curves across temperature and voltage.
2
Max values in this column apply for the full operating temperature range of the device unless otherwise
noted.
3
All modules except ADC active, ICS configured for FBELP, and does not include any dc loads on port pins
4
All modules except ADC active, ICS configured for FEI, and does not include any dc loads on port pins
5
Stop currents are tested in production for 25°C on all parts. Tests at other temperatures depend upon the
part number suffix and maturity of the product. Freescale may eliminate a test insertion at a particular
temperature from the production test flow once sufficient data has been collectd and is approved.
6
Most customers are expected to find that auto-wakeup from stop2 or stop3 can be used instead of the
higher current wait mode.
7
Values given under the following conditions: low range operation (RANGE = 0) with a 32.768kHz crystal
and low power mode (HGO = 0).
Table A-7. Supply Current Characteristics (continued)
Num C Parameter Symbol
V
DD
(V)
Typ
1
Max
2
Unit