Datasheet

Chapter 4 Clocks and Reset Generator (CRGV4)
MC9S12E128 Data Sheet, Rev. 1.07
Freescale Semiconductor 199
writes (0x0055 or 0x00AA) to the ARMCOP register must occur in the last 25% of the selected time-out
period. A premature write the CRG will immediately generate a reset.
As soon as the reset sequence is completed the reset generator checks the reset condition. If no clock
monitor failure is indicated and the latched state of the COP timeout is true, processing begins by fetching
the COP vector.
4.5.3 Power-On Reset, Low Voltage Reset
The on-chip voltage regulator detects when V
DD
to the MCU has reached a certain level and asserts
power-on reset or low voltage reset or both. As soon as a power-on reset or low voltage reset is triggered
the CRG performs a quality check on the incoming clock signal. As soon as clock quality check indicates
a valid oscillator clock signal the reset sequence starts using the oscillator clock. If after 50 check windows
the clock quality check indicated a non-valid oscillator clock the reset sequence starts using self-clock
mode.
Figure 4-26 and Figure 4-27 show the power-up sequence for cases when the
RESET pin is tied to V
DD
and when the RESET pin is held low.
Figure 4-26. RESET Pin Tied to V
DD
(by a Pull-Up Resistor)
Figure 4-27. RESET Pin Held Low Externally
RESET
Internal POR
128 SYSCLK
64 SYSCLK
Internal RESET
Clock Quality Check
(no Self-Clock Mode)
) (
) (
) (
Clock Quality Check
RESET
Internal POR
Internal RESET
128 SYSCLK
64 SYSCLK
(no Self-Clock Mode)
) (
) (
) (