Datasheet

Chapter 24 128 KByte Flash Module (S12XFTM128K2V1)

MC9S12XE-Family Reference Manual Rev. 1.25

868 Freescale Semiconductor

24.4.2.1 Erase Verify All Blocks Command

The Erase Verify All Blocks command will verify that all P-Flash and D-Flash blocks have been erased.

Upon clearing CCIF to launch the Erase Verify All Blocks command, the Memory Controller will verify

that the entire Flash memory space is erased. The CCIF ﬂag will set after the Erase Verify All Blocks

operation has completed.

24.4.2.2 Erase Verify Block Command

The Erase Verify Block command allows the user to verify that an entire P-Flash or D-Flash block has been

erased. The FCCOB upper global address bits determine which block must be veriﬁed.

Upon clearing CCIF to launch the Erase Verify Block command, the Memory Controller will verify that

the selected P-Flash or D-Flash block is erased. The CCIF ﬂag will set after the Erase Verify Block

operation has completed.

Table 24-33. Erase Verify All Blocks Command FCCOB Requirements

CCOBIX[2:0] FCCOB Parameters

000 0x01 Not required

Table 24-34. Erase Verify All Blocks Command Error Handling

FSTAT

ACCERR Set if CCOBIX[2:0] != 000 at command launch

FPVIOL None

MGSTAT1 Set if any errors have been encountered during the read

(1)

1. As found in the memory map for FTM256K2.

MGSTAT0 Set if any non-correctable errors have been encountered during the read

FERSTAT EPVIOLIF None

Table 24-35. Erase Verify Block Command FCCOB Requirements

CCOBIX[2:0] FCCOB Parameters

000 0x02

Global address [22:16] of the

Flash block to be veriﬁed