Datasheet

Chapter 28 768 KByte Flash Module (S12XFTM768K4V2)
MC9S12XE-Family Reference Manual Rev. 1.25
1136 Freescale Semiconductor
Figure 28-27. Flash Module Interrupts Implementation
28.4.4 Wait Mode
The Flash module is not affected if the MCU enters wait mode. The Flash module can recover the MCU
from wait via the CCIF interrupt (see Section 28.4.3, “Interrupts”).
28.4.5 Stop Mode
If a Flash command is active (CCIF = 0) or an EE-Emulation operation is pending when the MCU requests
stop mode, the current Flash operation will be completed before the CPU is allowed to enter stop mode.
28.5 Security
The Flash module provides security information to the MCU. The Flash security state is defined by the
SEC bits of the FSEC register (see Table 28-12). During reset, the Flash module initializes the FSEC
register using data read from the security byte of the Flash configuration field at global address
0x7F_FF0F.
Flash Error Interrupt Request
CCIF
CCIE
EPVIOLIF
EPVIOLIE
ERSVIF1
ERSVIE1
ERSVIF0
ERSVIE0
PGMERIF
PGMERIE
ERSERIF
ERSERIE
Flash Command Interrupt Request
DFDIF
DFDIE
SFDIF
SFDIE