Datasheet

128 KByte Flash Module (S12XFTMR128K1V1)
S12XS Family Reference Manual, Rev. 1.13
Freescale Semiconductor 581
(as evidenced by the Memory Controller returning CCIF to 1). Some commands return information to the
FCCOB register array.
The generic format for the FCCOB parameter fields in NVM command mode is shown in Table 19-24.
The return values are available for reading after the CCIF flag in the FSTAT register has been returned to
1 by the Memory Controller. Writes to the unimplemented parameter fields (CCOBIX = 110 and CCOBIX
= 111) are ignored with reads from these fields returning 0x0000.
Table 19-24 shows the generic Flash command format. The high byte of the first word in the CCOB array
contains the command code, followed by the parameters for this specific Flash command. For details on
the FCCOB settings required by each command, see the Flash command descriptions in Section 19.4.2.
19.3.2.12 Flash Reserved0 Register (FRSV0)
This Flash register is reserved for factory testing.
All bits in the FRSV0 register read 0 and are not writable.
Table 19-24. FCCOB - NVM Command Mode (Typical Usage)
CCOBIX[2:0] Byte FCCOB Parameter Fields (NVM Command Mode)
000
HI FCMD[7:0] defining Flash command
LO 0, Global address [22:16]
001
HI Global address [15:8]
LO Global address [7:0]
010
HI Data 0 [15:8]
LO Data 0 [7:0]
011
HI Data 1 [15:8]
LO Data 1 [7:0]
100
HI Data 2 [15:8]
LO Data 2 [7:0]
101
HI Data 3 [15:8]
LO Data 3 [7:0]
Offset Module Base + 0x000C
76543210
R00000000
W
Reset 00000000
= Unimplemented or Reserved
Figure 19-18. Flash Reserved0 Register (FRSV0)