Datasheet

5-30 MCF5407 User’s Manual
Background Debug Mode (BDM)
• Results are returned in the two serial transfer cycles after the memory access
completes. For any command performing a byte-sized memory read operation, the
upper 8 bits of the response data are undefined and the referenced data is returned in
the lower 8 bits. The next command’s opcode is sent to the debug module during the
final transfer. If a memory or register access is terminated with a bus error, the error
status (S = 1, DATA = 0x0001) is returned instead of result data.
5.5.3.3 Command Set Descriptions
The following sections describe the commands summarized in Table 5-21.
NOTE:
The BDM status bit (S) is 0 for normally completed
commands; S = 1 for illegal commands, not-ready responses,
and transfers with bus-errors. Section 5.5.2, “BDM Serial
Interface,” describes the receive packet format.
Motorola reserves unassigned command opcodes for future expansion. Unused command
formats in any revision level perform a
NOP and return an illegal command response.
5.5.3.3.1 Read A/D Register (
RAREG/RDREG)
Read the selected address or data register and return the 32-bit result. A bus error response
is returned if the CPU core is not halted.
Command/Result Formats:
Command Sequence:
Figure 5-21. RAREG/RDREG Command Sequence
Operand Data: None
Result Data: The contents of the selected register are returned as a longword
value, most-significant word first.
15 12 11 8 7 4 3 2 0
Command 0x2 0x1 0x8 A/D Register
Result D[31:16]
D[15:0]
Figure 5-20. RAREG/RDREG Command Format
XXX
MS RESULT
NEXT CMD
LS RESULT
RAREG/RDREG
???
XXX
BERR
NEXT CMD
"NOT READY"