Datasheet
Table Of Contents
- MCF5441x ColdFire Microprocessor Data Sheet
- 1 MCF5441x family comparison
- 2 Hardware design considerations
- 3 Pin assignments and reset states
- 4 Electrical characteristics
- 4.1 Absolute maximum ratings
- 4.2 Thermal characteristics
- 4.3 ESD protection
- 4.4 Static latch-up (LU)
- 4.5 DC electrical specifications
- 4.6 Output pad loading and slew rate
- 4.7 DDR pad drive strengths
- 4.8 Oscillator and PLL electrical characteristics
- 4.9 Reset timing specifications
- 4.10 FlexBus timing specifications
- 4.11 NAND flash controller (NFC) timing specifications
- 4.12 DDR SDRAM controller timing specifications
- 4.13 USB transceiver timing specifications
- 4.14 ULPI timing specifications
- 4.15 eSDHC timing specifications
- 4.16 SIM timing specifications
- 4.17 SSI timing specifications
- 4.18 12-bit ADC specifications
- 4.19 12-bit DAC timing specifications
- 4.20 mcPWM timing specifications
- 4.21 I2C timing specifications
- 4.22 Ethernet assembly timing specifications
- 4.23 32-bit timer module timing specifications
- 4.24 DSPI timing specifications
- 4.25 SBF timing specifications
- 4.26 1-Wire timing specifications
- 4.27 General purpose I/O timing specifications
- 4.28 Rapid general purpose I/O timing specifications
- 4.29 JTAG and boundary scan timing specifications
- 4.30 Debug AC timing specifications
- 5 Package information
- 6 Product documentation
- 7 Revision history
MCF5441x ColdFire Microprocessor Data Sheet, Rev. 8
Pin assignments and reset states
Freescale Semiconductor18
21
Configurable pull that is enabled and pulled down after reset.
22
The ALLPST signal is available only on the 196 MAPBGA package and allows limited debug trace functionality compared to the 256
MAPBGA package.
23
If JTAG_EN is asserted, these pins default to Alternate 1 (JTAG) functionality. The GPIO module is not responsible for assigning these
pins.
24
VSTBY is for optional standby lithium battery. If not used, connect to EVDD.