Information

3.8.5 CMT Configuration
This section summarizes how the module has been configured in the chip. For a
comprehensive description of the module itself, see the module’s dedicated chapter.
Signal multiplexing
Module signals
Register
access
CMT
Peripheral bus
controller 0
Figure 3-47. CMT configuration
Table 3-58. Reference links to related information
Topic Related module Reference
Full description Carrier modulator
transmitter (CMT)
CMT
System memory map System memory map
Clocking Clock distribution
Power management Power management
Signal multiplexing Port control Signal multiplexing
3.8.5.1 Instantiation Information
This device contains one CMT module.
3.8.5.2 IRO Drive Strength
The IRO pad requires higher current drive than can be obtained from a single pad. For
this device, the pin associated with the CMT_IRO signal is doubled bonded to two pads.
The SOPT2[CMTUARTPAD] field in SIM module can be used to configure the pin
associated with the CMT_IRO signal as a higher current output port pin.
Timers
K10 Sub-Family Reference Manual, Rev. 6, Nov 2011
130 Freescale Semiconductor, Inc.