Information

SAMPLES
Rx pin input
RT CLOCK
RT CLOCK COUNT
RESET RT CLOCK
1 1 1 1
0 0
START BIT
LSB
RT1 RT1 RT1 RT1 RT1 RT1 RT1 RT1 RT1 RT1 RT2 RT3
RT1 RT1 RT1 RT1 RT1 RT1 RT1 RT1 RT1
NO START BIT FOUND
1 1 1 1 1 1 1
0 0 0 0 0 0 0 0
RT4 RT5 RT6 RT7 RT1 RT1 RT1
Figure 45-226. Start bit search example 5 (C7816[ISO_7816E] = 0)
In the following figure, a noise burst makes the majority of data samples RT8, RT9, and
RT10 high. In this example C7816[ISO_7816E] = 0. This sets the noise flag but does not
reset the RT clock. In start bits only, the RT8, RT9, and RT10 data samples are ignored.
In this example, if C7816[ISO_7816E] = 1 then a start bit would not have been detected
at all since at least two of the three samples (RT8, RT9, RT10) were high.
SAMPLES
Rx pin input
RT CLOCK
RT CLOCK COUNT
RESET RT CLOCK
1 1 1 1
0 0
START BIT
LSB
RT1 RT1 RT1 RT1 RT1 RT1 RT1 RT1 RT1 RT1 RT2 RT3
RT10
RT1 RT2 RT3
1 1 1 1 1
0 0
1
0
1
RT4 RT5 RT6 RT7 RT8 RT9
RT11
RT12
RT13 RT14 RT15
RT16
Figure 45-227. Start bit search example 6
45.4.2.5 Framing errors
If the data recovery logic does not detect a logic 1 where the stop bit should be in an
incoming frame, it sets the framing error flag, S1[FE] if S2[LBKDE] is disabled. A break
character when S2[LBKDE] is disabled also sets the S1[FE] because a break character
has no stop bit. The S1[FE] is set at the same time that received data is placed in the
receive data buffer. Framing errors are not supported when C7816[ISO7816E] is set/
enabled. However, if the S1[FE] is set data will not be received when C7816[ISO7816E]
is set.
Functional description
K10 Sub-Family Reference Manual, Rev. 6, Nov 2011
1310 Freescale Semiconductor, Inc.