Information

TSIx_GENCS field descriptions (continued)
Field Description
0 Disable
1 Enable
5
ERIE
TSI error interrupt Enable
Caused by a short or overrun error.
0 Error interrupt disabled
1 Error interrupt enabled
4
ESOR
End-of-scan or out-of-range interrupt select
0 Out-of-range interrupt selected
1 End-of-scan interrupt selected
3
Reserved
Reserved
This field is reserved.
2
Reserved
Reserved
This field is reserved.
1
STM
Scan trigger mode
0 Software trigger scan
1 Periodical scan
0
STPE
TSI stop enable while in low-power modes (STOP, VLPS, LLS, and VLLS{3,2,1})
0 Disable TSI when MCU enters low-power modes
1 Allow TSI to continue running in all low power modes
49.6.2 SCAN control register (TSIx_SCANC)
All SCANC bits can be read at any time, but must not be written while GENCS[SCNIP]
is set.
Addresses: TSI0_SCANC is 4004_5000h base + 4h offset = 4004_5004h
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
R
REFCHRG CAPTRM EXTCHRG DELVOL
W
Reset
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Bit
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
SMOD
0
AMCLKDIV
AMCLKS AMPSC
W
Reset
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Chapter 49 Touch sense input (TSI)
K10 Sub-Family Reference Manual, Rev. 6, Nov 2011
Freescale Semiconductor, Inc. 1541