Information

FTMx_OUTMASK field descriptions (continued)
Field Description
0
CH0OM
Channel 0 Output Mask
Defines if the channel output is masked (forced to its inactive state) or unmasked (it continues to operate
normally).
0 Channel output is not masked. It continues to operate normally.
1 Channel output is masked. It is forced to its inactive state.
37.3.14 Function for Linked Channels (FTMx_COMBINE)
This register contains the control bits used to configure the fault control, synchronization,
deadtime insertion, dual edge capture mode, complementary, and combine mode for each
pair of channels (n) and (n+1), where n equals 0, 2, 4, and 6.
Addresses: FTM0_COMBINE is 4003_8000h base + 64h offset = 4003_8064h
FTM1_COMBINE is 4003_9000h base + 64h offset = 4003_9064h
FTM2_COMBINE is 400B_8000h base + 64h offset = 400B_8064h
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
R
0
FAULTEN3
SYNCEN3
DTEN3
DECAP3
DECAPEN3
COMP3
COMBINE3
0
FAULTEN2
SYNCEN2
DTEN2
DECAP2
DECAPEN2
COMP2
COMBINE2
W
Reset
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Bit
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
0
FAULTEN1
SYNCEN1
DTEN1
DECAP1
DECAPEN1
COMP1
COMBINE1
0
FAULTEN0
SYNCEN0
DTEN0
DECAP0
DECAPEN0
COMP0
COMBINE0
W
Reset
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
FTMx_COMBINE field descriptions
Field Description
31
Reserved
This read-only field is reserved and always has the value zero.
30
FAULTEN3
Fault Control Enable for n = 6
Enables the fault control in channels (n) and (n+1).
This field is write protected. It can be written only when MODE[WPDIS] = 1.
0 The fault control in this pair of channels is disabled.
1 The fault control in this pair of channels is enabled.
Table continues on the next page...
Chapter 37 FlexTimer (FTM)
K10 Sub-Family Reference Manual, Rev. 6, Nov 2011
Freescale Semiconductor, Inc. 907