Information

NOTE
The channels (n) and (n+1) are in output compare, EPWM, CPWM or combine modes.
pair channels (m) - channels (n) and (n+1)
initialization
complementary
mode
inverting
software
output
control
deadtime
insertion
output
mask
fault
control
polarity
control
FTM counter
QUADEN
DECAPEN
COMBINE(m)
CPWMS
C(n)V
MS(n)B
MS(n)A
ELS(n)B
ELS(n)A
generation of
channel (n)
output signal
generation of
channel (n+1)
output signal
C(n+1)V
MS(n+1)B
MS(n+1)A
ELS(n+1)B
ELS(n+1)A
channel
(n)
output
signal
channel
(n+1)
output
signal
CH(n)OI
CH(n+1)OI
COMP(m)
INV(m)EN
CH(n)OC
CH(n)OCV
CH(n+1)OC
CH(n+1)OCV
DTEN(m)
CH(n)OM
CH(n+1)OM
FAULTEN(m)
POL(n)
POL(n+1)
Figure 37-237. Priority of the Features Used at the Generation of Channels (n) and (n+1)
Outputs Signals
Note
It is expected that the initialization feature (Initialization) is not
used with inverting (Inverting) and software output control
(Software Output Control) features.
37.4.20 Channel Trigger Output
If CHjTRIG = 1 (where j = 0, 1, 2, 3, 4, or 5), then the FTM generates a trigger when the
channel (j) match occurs (FTM counter = C(j)V).
The channel trigger output provides a trigger signal that is used for on-chip modules.
Chapter 37 FlexTimer (FTM)
K10 Sub-Family Reference Manual, Rev. 6, Nov 2011
Freescale Semiconductor, Inc. 987