Datasheet

Selectable clock for prescaler/glitch filter
1 kHz internal LPO
External low power crystal oscillator
Internal reference clock (not available in low leakage power modes)
Secondary external reference clock (for example, 32 kHz crystal)
Configurable glitch filter or prescaler
Interrupt generated on timer compare
Hardware trigger generated on timer compare
4.5.6.5 Carrier Modulator Timer (CMT)
Four modes of operation
Time with independent control of high and low times
Baseband
Frequency shift key (FSK)
Direct software control of CMT_IRO signal
Extended space operation in time, baseband, and FSK modes
Selectable input clock divider
Interrupt on end of cycle
Ability to disable CMT_IRO signal and use as timer interrupt
4.5.6.6 Real-Time Clock (RTC)
Independent power supply, POR and 32 kHz crystal oscillator
32-bit seconds counter with 32-bit alarm
16-bit prescaler with compensation
Register write protection
Hard Lock requires VBAT POR to enable write access
Soft lock requires system reset to enable write/read access
Communication interfaces
4.5.7.1 USB On-The-Go Module (FS/LS)
Complies with USB specification rev 2.0
USB host mode
Supports enhanced-host-controller interface (EHCI)
Allows direct connection of FS/LS devices without an OHCI/UHCI companion controller
Supported by Linux and other commercially available operating systems
USB device mode
Full-speed operation via the on-chip transceiver
Supports one upstream facing port
Supports four programmable, bidirectional USB endpoints, including endpoint 0
Suspend mode/low power
As host, firmware can suspend individual devices or the entire USB and disable chip clocks for low-power
operation
Device supports low-power suspend
Remote wake-up supported for host and device
Integrated with the processor’s low power modes
Includes an on-chip full-speed (12 Mbps) and low-speed (1.5 Mbps) transceiver
4.5.7
Communication interfaces
K20 Family Product Brief, Rev. 11, 08/2012
42 Freescale Semiconductor, Inc.