Information

LLWU_F3 field descriptions (continued)
Field Description
Indicates that an enabled internal peripheral was a source of exiting a low-leakage power mode. To clear
the flag, follow the internal peripheral flag clearing mechanism.
0 Module 0 input was not a wakeup source
1 Module 0 input was a wakeup source
16.3.9 LLWU Pin Filter 1 register (LLWU_FILT1)
LLWU_FILT1 is a control and status register that is used to enable/disable the digital
filter 1 features for an external pin.
NOTE
This register is reset on Chip Reset not VLLS and by reset
types that trigger Chip Reset not VLLS. It is unaffected by reset
types that do not trigger Chip Reset not VLLS. See the
Introduction details for more information.
Address: LLWU_FILT1 is 4007_C000h base + 8h offset = 4007_C008h
Bit 7 6 5 4 3 2 1 0
Read FILTF
FILTE
0
FILTSEL
Write w1c
Reset
0 0 0 0 0 0 0 0
LLWU_FILT1 field descriptions
Field Description
7
FILTF
Filter Detect Flag
Indicates that the filtered external wakeup pin, selected by FILTSEL, was a source of exiting a low-
leakage power mode. To clear the flag write a one to FILTF.
0 Pin Filter 1 was not a wakeup source
1 Pin Filter 1 was a wakeup source
6–5
FILTE
Digital Filter On External Pin
Controls the digital filter options for the external pin detect.
00 Filter disabled
01 Filter posedge detect enabled
10 Filter negedge detect enabled
11 Filter any edge detect enabled
4
Reserved
This read-only field is reserved and always has the value zero.
Table continues on the next page...
Chapter 16 Low-Leakage Wakeup Unit (LLWU)
K20 Sub-Family Reference Manual, Rev. 2, Feb 2012
Freescale Semiconductor, Inc. 305