Information

FTFL_FCCOBn field descriptions (continued)
Field Description
The following table shows a generic flash command format. The first FCCOB register, FCCOB0, always
contains the command code. This 8-bit value defines the command to be executed. The command code
is followed by the parameters required for this specific flash command, typically an address and/or data
values.
NOTE: The command parameter table is written in terms of FCCOB Number (which is equivalent to the
byte number). This number is a reference to the FCCOB register name and is not the register
address.
FCCOB Number Typical Command Parameter Contents [7:0]
0 FCMD (a code that defines the flash command)
1 Flash address [23:16]
2 Flash address [15:8]
3 Flash address [7:0]
4 Data Byte 0
5 Data Byte 1
6 Data Byte 2
7 Data Byte 3
8 Data Byte 4
9 Data Byte 5
A Data Byte 6
B Data Byte 7
FCCOB Endianness and Multi-Byte Access :
The FCCOB register group uses a big endian addressing convention. For all command parameter fields
larger than 1 byte, the most significant data resides in the lowest FCCOB register number. The FCCOB
register group may be read and written as individual bytes, aligned words (2 bytes) or aligned longwords
(4 bytes).
28.34.6 Program Flash Protection Registers (FTFL_FPROTn)
The FPROT registers define which logical program flash regions are protected from
program and erase operations. Protected flash regions cannot have their content changed;
that is, these regions cannot be programmed and cannot be erased by any flash command.
Unprotected regions can be changed by program and erase operations.
The four FPROT registers allow 32 protectable regions. Each bit protects a 1/32 region of
the program flash memory. The bitfields are defined in each register as follows:
Memory Map and Registers
K20 Sub-Family Reference Manual, Rev. 2, Feb 2012
514 Freescale Semiconductor, Inc.