Information

NOTE
(c)
(a) LDOK = 0, CH0SEL = 0, CH1SEL = 0, CH2SEL = 0, CH3SEL = 0, CH4SEL = 0, CH5SEL = 0, CH6SEL = 0, CH7SEL = 0
(b) LDOK = 1, CH0SEL = 0, CH1SEL = 0, CH2SEL = 0, CH3SEL = 0, CH4SEL = 0, CH5SEL = 0, CH6SEL = 0, CH7SEL = 0
(c) LDOK = 0, CH0SEL = 0, CH1SEL = 0, CH2SEL = 0, CH3SEL = 1, CH4SEL = 0, CH5SEL = 0, CH6SEL = 0, CH7SEL = 0
(d) LDOK = 1, CH0SEL = 0, CH1SEL = 0, CH2SEL = 0, CH3SEL = 0, CH4SEL = 0, CH5SEL = 0, CH6SEL = 1, CH7SEL = 0
(e) LDOK = 1, CH0SEL = 1, CH1SEL = 0, CH2SEL = 1, CH3SEL = 0, CH4SEL = 1, CH5SEL = 0, CH6SEL = 1, CH7SEL = 0
(f) LDOK = 1, CH0SEL = 1, CH1SEL = 1, CH2SEL = 1, CH3SEL = 1, CH4SEL = 1, CH5SEL = 1, CH6SEL = 1, CH7SEL = 1
(d)
(e)
(f)
(b)
(a)
FTM counter = MOD
FTM counter = C7V
FTM counter = C6V
FTM counter = C5V
FTM counter = C4V
FTM counter = C3V
FTM counter = C2V
FTM counter = C1V
FTM counter = C0V
Figure 35-216. Loading points for intermediate load
After enabling the loading points, the LDOK bit must be set for the load to occur. In this
case, the load occurs at the next enabled loading point according to the following
conditions:
Table 35-195. Conditions for loads occurring at the next enabled loading point
When a new value was written Then
To the MOD register The MOD register is updated with its write buffer value.
To the CNTIN register and CNTINC = 1 The CNTIN register is updated with its write buffer value.
To the C(n)V register and SYNCENm = 1 – where m
indicates the pair channels (n) and (n+1)
The C(n)V register is updated with its write buffer value.
To the C(n+1)V register and SYNCENm = 1 – where m
indicates the pair channels (n) and (n+1)
The C(n+1)V register is updated with its write buffer value.
NOTE
• If ELSjB and ELSjA bits are different from zero, then the
channel (j) output signal is generated according to the
configured output mode. If ELSjB and ELSjA bits are zero,
Functional description
K20 Sub-Family Reference Manual, Rev. 2, Feb 2012
814 Freescale Semiconductor, Inc.