Information

SPIx_PUSHR field descriptions (continued)
Field Description
Selects which CTAR to use in master mode to specify the transfer attributes for the associated SPI frame.
In SPI Slave mode, CTAR0 is used. See the chapter on chip configuration to determine how many CTARs
this device has. You should not program a value in this field for a register that is not present.
000 CTAR0
001 CTAR1
010 Reserved
011 Reserved
100 Reserved
101 Reserved
110 Reserved
111 Reserved
27
EOQ
End Of Queue
Host software uses this bit to signal to the DSPI that the current SPI transfer is the last in a queue. At the
end of the transfer, the EOQF bit in the SR is set.
0 The SPI data is not the last data to transfer.
1 The SPI data is the last data to transfer.
26
CTCNT
Clear Transfer Counter
Clears the TCNT field in the TCR register. The TCNT field is cleared before the DSPI starts transmitting
the current SPI frame.
0 Do not clear the TCR[TCNT] field.
1 Clear the TCR[TCNT] field.
25–24
Reserved
This read-only field is reserved and always has the value zero.
23–22
Reserved
This read-only field is reserved and always has the value zero.
21–16
PCS[5:0]
Select which PCS signals are to be asserted for the transfer. Refer to the chip configuration chapter for
the number of PCS signals used in this MCU.
0 Negate the PCS[x] signal.
1 Assert the PCS[x] signal.
15–0
TXDATA
Transmit Data
Holds SPI data to be transferred according to the associated SPI command.
Memory Map/Register Definition
K20 Sub-Family Reference Manual, Rev. 2, Feb 2012
980 Freescale Semiconductor, Inc.