Datasheet

MPC5566 Microcontroller Data Sheet, Rev. 3

Electrical Characteristics

Freescale Semiconductor12

During initial power ramp-up, when V

stby

is 0.6v or above. a typical current of 1-3mA and maximum of

4mA may be seen until V

is applied. This current will not reoccur until V

stby

is lowered below V

stby

min. specification.

Figure 2 shows an approximate interpolation of the I

STBY

worst-case specification to estimate values at

different voltages and temperatures. The vertical lines shown at 25



C, 60



C, and 150



C in Figure 2 are

the actual I

DD_STBY

specifications (27d) listed in Table 9.

Figure 2. fI

STBY

Worst-case Specifications