Datasheet

Appendix A Electrical Characteristics
MC9S08SG8 MCU Series Data Sheet, Rev. 8
294 Freescale Semiconductor
Figure A-5. Typical Run I
DD
vs. Bus Frequency (V
DD
= 5V)
6C
RTC adder to stop2 or stop3
7
S23I
DDR
TI
5 300 500 nA x
3 300 500 nA x
7C
LVD adder to stop3 (LVDE = LVDSE
= 1)
S3I
DDLVD
5 110 180 Ax
390160Ax
8C
Adder to stop3 for oscillator
enabled
8
(EREFSTEN =1)
S3I
DDOS
C
5,
3
58A
x
x
1
Typical values are based on characterization data at 25C. See Figure A-5 through Figure A-7 for typical curves across
voltage/temperature.
2
Max values in this column apply for the full operating temperature range of the device unless otherwise noted.
3
Electrical characteristics only apply to the temperature rated devices marked with x.
4
All modules except ADC active, ICS configured for FBE, and does not include any dc loads on port pins.
5
All modules except ADC active, ICS configured for FEI, and does not include any dc loads on port pins.
6
Stop currents are tested in production for 25C on all parts. Tests at other temperatures depend upon the part number suffix
and maturity of the product. Freescale may eliminate a test insertion at a particular temperature from the production test flow
once sufficient data has been collected and is approved.
7
Most customers are expected to find that auto-wakeup from stop2 or stop3 can be used instead of the higher current wait mode.
8
Values given under the following conditions: low range operation (RANGE = 0) with a 32.768kHz crystal and low power mode
(HGO = 0).
Table A-7. Supply Current Characteristics (continued)
Num C Parameter Symbol
V
DD
(V)
Typ
1
Max
2
Unit
Temp Rated
3
Standard
AEC
Grade 0
Run I
DD
(mA)
f
bus
(MHz)
8421016
0
2
4
10
20
6
8
FEI
FBELP