Datasheet

Electrical Characteristics
MC9S12G Family Reference Manual, Rev.1.23
Freescale Semiconductor 1207
Table A-15. Run and Wait Current Characteristics (Junction Temperature From –40°C To +150°C)
TIM
The peripheral shall be configured to output compare mode,
pulse accumulator and modulus counter enabled.
COP & RTI Both modules are enabled.
ACMP
1
The module is enabled with analog output on. The ACMPP
and ACMPM are toggling with 0-1 and 1-0.
DAC
2
DAC0 and DAC1 is buffered at full voltage range
(DACxCTL = $87).
RVA
3
The module is enabled and ADC is running at 6.25MHz with
maximum bus freq
1
Onlly available on S12GN16, S12GN32, S12GN48, S12G48, and S12G64
2
Only available on S12G192, S12GA192, S12G340, and S12GA240
3
Only available on S12GA192 and S12GA240
Conditions are: V
DDR
=5.5V, T
A
=125°C, see Table A-13. and Table A-14.
Num C Rating Symbol Min Typ Max Unit
S12GN16, S12GN32
1 P IDD Run Current (code execution from RAM) I
DDRr
12.5 16 mA
2 C IDD Run Current (code execution from flash) I
DDRf
13 17 mA
3 P IDD Wait Current I
DDW
7.2 10 mA
S12GN48, S12G48, S12G64
4 P IDD Run Current (code execution from RAM) I
DDRr
14 19 mA
5 C IDD Run Current (code execution from flash) I
DDRf
15.5 20 mA
6 P IDD Wait Current I
DDW
8.7 11 mA
S12G96, S12G128
7 P IDD Run Current (code execution from RAM) I
DDRr
15 21 mA
8 C IDD Run Current (code execution from flash) I
DDRf
17 22 mA
9 P IDD Wait Current I
DDW
9 11.5 mA
S12G192, S12GA192, S12G240, S12GA240
10 P IDD Run Current (code execution from RAM) I
DDRr
18 22.5 mA
11 C IDD Run Current (code execution from flash) I
DDRf
17 23.5 mA
12 P IDD Wait Current I
DDW
9.5 12 mA
Table A-14. Peripheral Configurations for Run & Wait Current Measurement
Peripheral Configuration