Datasheet

Revision History
MPC5674F Microcontroller Data Sheet, Rev. 9
Freescale Semiconductor 129
4
(cont)
“Temperature Sensor Electrical Specifications” table: Changed spec #2 to have one temperature range (-40 - 150
C) and changed spec value from ±1.0 to ±10.0 C.
“eQADC Conversion Specifications (Operating)” table: Changed spec #13 (non-disruptive injection current)
values from ±1 to ±3.
"IPCLKDIV Settings" table, removed footnote "eMIOS and DMA are not considered peripherals here."
5
(Feb-2011)
Note 4 in Maximum Ratings updated from 2.0 V to 1.65 V.
Changed I/O Supply Voltage spec in DC Electrical specs, Spec 2, from 1.62 V min to 3.0 V min.
Changed the APC=RWSC value in line 1 of PFCPR1 Settings vs. Frequency of Operation table from 0b011 to
0b100
Changed note 1 for Pad AC Specifications table from Vdde = 1.62 V to 1.98 V to read Vdde = 3.0 V to 3.6 V
Changed note 6 for Signal Properties and Muxing Summary table by removing the voltage range 1.8 V - 3.3 V
to have 3.3 V instead of the range.
Spec 2 in Table 9 “ESD Ratings“ the spec for “ESD for Charged Device Model (CDM)” changed to 250 V (other)
from 500 V (other)
Removed voltage ranges 1.62-1.98 V and 2.25-2.75 V from spec 28 in Table 14
6
(Feb-2011)
Same content as for Rev. 5
7
(Mar-2011)
Added entry for Rev. 6 and Rev. 7 to this table to fix a revision-numbering issue.
8
(Jun-2011)
Added the following footnotes to the “Signal Properties and Muxing Summary” table:
• Footnote 10, for the ANA[0:7] signals, “During and just after POR negates, internal pull resistors can be
enabled, resulting in as much as 4 mA of current draw. The pull resistors are disabled when the system clock
propagates through the device.”
• Footnote 15, for MDO[0:15] and MSEO[0:1] signals, “Do not connect pin directly to a power supply or ground.”
Changed min and max values of ID 1 “Nominal bandgap reference voltage“ in Table 11 (PMC Electrical
Specifications) to 0.608 V min and 0.632 V max.
Changed min and max values of Spec 2 “ADC Bandgap” in Table 23 (ADC Band Gap Reference/LVI Electrical
Specifications) to 1.171 V min and 1.269 V max.
Changed Spec 3 of Table 26 (Flash EEPROM Module Life) from 'Minimum Data Retention at 25 °C ambient
temperature' to 'Minimum Data Retention at 85 °C ambient temperature'
Added Spec 41, 42, 43 and 44 to the “DC Electrical Specifications” table
Added Note 25 to the “DC Electrical Specifications” table for Spec 41, 42 and 43
Added Note 26 to the “DC Electrical Specifications” for Spec 44
Added Spec 17 to the “eQADC Conversion Specifications (Operating)” table.
Added Spec 18 to the “eQADC Conversion Specifications (Operating)” table.
Added Note 15 to the “eQADC Conversion Specifications (Operating)” table for Spec 17 and 18.
Table 46. Revision History (continued)
Revision
(Date)
Description of changes