Information

Errata ID Errata Title
3553 NXFR: Flexray databus translates into unexpected data format on the Nexus interface
1279 NZ7C3:Core Nexus Read/Write Access registers cleared by system reset
7120 NZxC3: DQTAG implemented as variable length field in DQM message
2696 PBRIDGE: Write buffer may cause overflow/underflow of DMA transfers
2996 PIT_RTI: RTI timer corruption when debugging
2322 PMC: LVREH/LVREA/LVRE50 may exit LVI triggered reset with LVI condition still existing
3377 Pad Ring:Nexus pins may drive an unknown value immediately after power up but before the 1st clock
edge
1419 SIU: Reverting ENGCLK source to the system clock has a very small chance of causing the ENGCLK
generator to enter an indeterminate state
4396 e200z7: Erroneous Address Fetch
3419 e200z: Exceptions generated on speculative prefetch
6966 eDMA: Possible misbehavior of a preempted channel when using continuous link mode
4480 eQADC: Differential conversions with 4x gain may halt command processing
5086 eQADC: unexpected result may be pushed when Immediate Conversion Command is enabled
2386 eSCI : No LIN frame reception after leaving stop mode
1171 eSCI : DMA stalled after return from stop or doze mode
2396 eSCI : Stop Mode not entered in LIN mode
1297 eSCI : reads of the SCI Data Register, which clears the RDRF flag, may cause loss of frame if read
occurs during reception of the STOP bit
1381 eSCI: LIN Wakeup flag set after aborted LIN frame transmission
1221 eSCI: LIN bit error indicated at start of transmission after LIN reset
e3521: DECFIL: Soft reset failures at the end of filtering
Errata type: Errata
Description: If a software reset of a decimation filter is made exactly at the time it finishes filtering, several
registers reset for one clock, but have their values updated by the filtering on the next clock,
including (but not limited to) the integrator current value register DECFIL_CINTVAL and
the tap registers DECFILTER_TAPn.
Workaround: Before making the soft reset write (DECFIL_MCR bit SRES=1), perform the procedure below:
1- disable filter inputs, writing DECFIL_MCR bit IDIS = 1.
2- read the register DECFIL_MSR and repeat the read until the bit BSY is 0.
3- repeat the loop of step 2; this is necessary to cover the case when a sample is left in the
input buffer.
e6026: DSPI: Incorrect SPI Frame Generated in Combined Serial Interface
Configuration
Errata type: Errata
Mask Set Errata for Mask 3M17W, Rev 13 SEP 2013
2 Freescale Semiconductor, Inc.