Datasheet

NXP Semiconductors
UM11183
KITFS85SKTEVM evaluation board
UM11183 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2019. All rights reserved.
User manual Rev. 3 — 6 December 2019
18 / 51
Name Function Pin
number
Jumper/pin function
1−2 VMON2 tied to 0.8 V
J23 VMON2
2−3 VMON2 tied to BUCK2
1−2 VMON3 tied to 0.8 V
J24 VMON3
2−3 VMON3 tied to BUCK3
J25 RSTB
1−2 Reset LED
Enabled when jumper is plugged
J26 INTB
1−2 Interrupt LED
Enabled when jumper is plugged
J27 FS0B
1−2 FS0B LED
Enabled when jumper is plugged
J29 — — —
J30 — — —
J31 — — Use only during board manufacturing
J32 PGOOD
1−2 PGOOD LED
Enabled when jumper is plugged
4.3.6 Switches
Figure 17. Switch locations
Table 13. SW3
Position Function Description
RIGHT OTP programming Off OTP burning not possible
LEFT OTP programming On 8.0 V on DBG pin allows OTP
burning (blue LED turns On to
indicate this state)