Datasheet

NXP Semiconductors
UM11183
KITFS85SKTEVM evaluation board
UM11183 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2019. All rights reserved.
User manual Rev. 3 — 6 December 2019
33 / 51
8 Using FlexGUI
To follow the steps in this section, make sure that the board is connected using the
appropriate hardware configuration (see Section 7.2 "Working in OTP emulation mode").
Note: It is recommended to use the latest version of FlexGUI.
8.1 Starting the FlexGUI application
After FlexGUI is launched with the flexgui-app.bat file, the FlexGUI launcher displays
available kits.
Communication bus, SPI or I2C can be selected at this level. It is also possible to switch
from one to the other using the communication tab from the main panel (see Section 8.2
"Establishing the connection between FlexGUI and the hardware").
Figure 23. Launcher panel - bus selection