User Guide

3
QUICK START GUIDE MC56F80000-EVK
OPERATION NOTES
1. MC56F80000-EVK can be powered by either of the USB connectors (J12, J26), or
the adapter input (J7). Beware that only an adapter with 5V output can be used.
2. When the board is powered up, a green LED D2 will illuminate, indicating 3.3V is
on. If the board is powered by USB connector (J12), an orange LED D4 will also
illuminate, indicating K26 is powered.
3. J12 is the on-board OPENSDA (realized by K26) connector which can be used to
debug/program MC56F80748. It provides a virtual serial port as well.
4. J26 is the virtual serial port connector. CP210x USB to UART bridge VCP Drivers are
needed. CP210x is not populated by default on the board.
5. J10 is the JTAG connector for MC56F80748. Remember to remove four jumpers
on J13 when this JTAG is used. This is to avoid the impact of on-board OPENSDA
circuit.
6. Pin2 and pin3 of J11 are connected by default to enable the external reset from
SW1.