Daim Ntawv Qhia Tus Neeg Siv

7.3.1 Connecting the Debugging cable
The FreeMASTER debug connection uses J-Link, as shown in the following figure. The J-Link tool can be connected through the
connector J1. The FreeMASTER version should be V3.1 or higher.
Figure 14. FreeMASTER debugging connection
7.3.2 FreeMASTER project options setting
1. Set the symbol file for your project. Select the symbol file in FreeMASTER Project –> Options –> MAP Files, as shown
below.
Figure 15. Select Symbol File
2. Select the communication interface for Freemaster: Select "Plug-in Module" in Freemaster Project –> Options –> Comm
as shown below. Then select "FreeMASTER Segger/Jlink Communication Plug-in".
NXP Semiconductors
Getting Started
WPR1500-HV Wireless Charging Receiver Application User’s Guide, Rev. 3.0, 4 July 2022
User Guide 10 / 17