TAKE GOOD CARE OF GOOD FURNITURE “Take good care of good furniture” is published by the Danish Furnituremakers’ Quality Control, whose objective it is to promote the manufacturing of high quality furniture in Denmark. Dansk Møbelkontrol Søren Frichs Vej 50 DK-8230 Aabyhøj www.dansk-mobelkontrol.
IMPORTANT ADVICE ON FURNITURE MAINTENANCE Warning! Never use solvents (e.g. methylated spirits, white spirit, thinner, benzine, acetone etc.) unless the manufacturer’s instructions explicitly state that this is allowed. Solvents are inflammable, dangerous to inhale, and can damage surface treatment on wood, leather and other materials. They can also damage upholstery materials if they are used to clean textiles. THE FOLLOWING RULES MUST ALSO BE OBSERVED: 1.
CLEANING SOLUTIONS Soap solution is made with 1 part soap flakes to 40 parts hot water. Cool before use. Soft soap should not be used unless this is explicitly recommended in the manufacturer’s instructions. Solution with washing-up liquid: Follow the manufacturer’s instructions. Use no more than 1 tsp. washing-up liquid per litre water. When using concentrated liquids, a few drops per litre water will suffice. TAKE GOOD CARE OF GOOD FURNITURE All good things that are made to last need care.
MAINTENANCE OF WOODEN FURNITURE SURFACES UNTREATED AND SOAP-TREATED SOLID WOOD SURFACES General maintenance: Wipe with a clean dry cloth. Soiled surfaces should be wiped with a cloth wrung out in soap solution (see Cleaning Solutions). Soft soap should only be used on pine (soft woods) where it leaves a light grey patina. On oak and other woods with a high percentage of tannic acid the use of soft soap can result in a strong dark colour.
TREATMENT OF OTHER FURNITURE SURFACES METAL FURNITURE The most common metals used in furniture production today are aluminium and chromiumplated, lacquered or stainless steel. All these surfaces are resistant to dirt as well as liquids. However, water can stain aluminium and stainless steel as well as cause damaged chromiumplated and lacquered steel surfaces to rust. General maintenance: Wipe with a cloth wrung out in water and washing-up liquid (see Cleaning Solutions).
seats. Flax is sensitive to dirt and is easily stained. A cigarette ember that is quickly removed usually leaves a small hole. Synthetic fibres such as polyamide and polyester (including micro fibre materials and Trevira CS) are generally hardwearing and easy to clean. A cigarette ember that is quickly removed usually leaves a small hole. FURNITURE TEXTILE MAINTENANCE General maintenance: Vacuum clean often, at least once a week.
with a clean soft cloth wrung out in soap solution (see Cleaning Solutions). Spilt liquids etc. must be wiped off immediately. Do not vacuum as this may scratch the surface. Removal of spots is not advisable! Washingup liquids and solvents should not be used. Leather cream or leather oil should only be used when absolutely necessary. Warning! If the surface is damaged or worn, leather cream or oil can cause blotches or discolouring.
CHARACTERISTICS OF GENUINE LEATHER HEALED WOUNDS – usually caused by cuts from barbed wire, thorns or fights. They do not reduce the strength of the leather. INSECT BITES – small circular marks or holes in the leather. They do not reduce the strength of the leather. OPEN WOUNDS – causes as for healed wounds. They can reduce the strength of the leather and should therefore not be used where there is a risk of significant wear and tear. NECK WRINKLES – coarse surface structure caused by growth.
