User's Manual

User Manual of NZC110-EXT
44
Chapter 6 Logout
Click the logout button, it will logout the device and return to the login page.




Chapter 7 FAQ
1. The device cannot be started after power on.
ᴺ The Ethernet cable between the device and the POE adaptor is more than 40
meters long.
ᴻ The Ethernet cable quality is not good enough, and it should be Cat 5e or even Cat
6 cable.
ᴼ The RJ-45 plugs are not well connected.
2. Forgot the IP address of the device.
Please manually push the Reset button for 5~10 seconds and wait 2 or 3 minutes, then the
user can log in the device by typing the default IP address 192.168.1.1.
3. How to modify the IP address of the device?
Please open the device page, followed by click Network - > interfaces - > select Edit
button of the LAN interface - >Common Configuration - >General Setup ->IPv4 address;
here you can set the IP address according to your own needs. But you should ensure the
IP you edit is different with other devices, so as to avoid IP address conflict.
4. The signal level or the wireless TX/RX rate is low
ᴺ There is a large bunker between Client and access point. Please remove or bypass
the bunker.