User's Manual



User Manual of NZC110-EXT

5. Multiple devices are installed at the same area, the packet loss is

serious. Change channel can only improve the situation for a while.

ᴺ Multiple devices are installed at the same area, and there is no plan for thefrequency

settings which will cause the same frequency interference. It is recommendedto separate

the frequency of the devices. If the channel width is 20M, the frequencydifference

between two devices should be more than 20MHz. For example, 2412MHz,2432MHz,

2452MHz etc., or set to non-standard frequency: Click Network - > Wifi - >select the

corresponding wireless network SSID and click Edit > Advanced Settings - >Country, select

Compliance Test - > Click Save & Apply button, then click General Setup ->modify the

basic channel and save the application.

ᴻ Multiple devices IP conflict with each other; you need to modify the IP address

followed by click Network - > Interfaces -> General Setup ->IPv4 address. Please

reference manual 5.1.1 Common Configuration section.

6. Mobile phones and computers cannot connect to AP

TDMA function is not closed, please close the TDMA. Followed by click Network - > Wifi

- > select corresponding SSID and click Edit button > Advanced Settings - > check off

TDMA.

7. Clients often dropped, the speed is slow.

ᴽ There are too many clients connect to AP, please limit the number of access users.

ᴾ AP signal is weak. Please improve AP transmission power or regulating the AP and

the user's position.

ᴿ Check the saturation of users and network bandwidth.