Instructions / Assembly

ASSEMBLY

PREPARATION

Before beginning assembly, empty contents of carton and make sure all parts are present. Place all parts on a soft, level

surface for assembly. NOTE: It is best to use TWO PEOPLE to assemble this gas fire pit.

Estimated Assembly Time: 60 Minutes | DO NOT over tighten hardware!

Assemble the ﬁre pit base:Locate Door Panel D ,3 Side Panels

E Door Frame Leg F and 2 Support Legs G

Screw Studs O into the holes in the sides of all four legs

,including

the leg pre-assembled to the door,

Beginning with Door Frame Leg F join the Legs and Panels

together by ﬁtting the holes on the sides of the Side Panels onto

the Studs installed earlier.

To secure the Legs to the Panels,place a Washer Q then a S

pring

Washer R onto each Stud,then thread a Nut S onto each Stud.

Do not tighten the hardware until the entire base is assembled.

Then ﬁrmly tighten all Nuts with the Wrench V,but DO NOT

OVERTIGHTEN.

Hardware Used:

Place Table Top C so underside faces up.Screw 4 Studs M into

the holes on the Table Top with Screwdriver U.

Then carefully turn the assembled ﬁre pit base upside-down

and align the holes in the top of the Legs with the Studs

in the Table Top.

Place the holes over the Studs and secure each with Washer

/Spring Washer/Nut N as illustrated.

Tighten with Wrench V.Then place Plastic Caps T over Nuts.