Instructions / Assembly

6
ASSEMBLY
Hardware Used: P Bolt (6x16mm) x 5
Q Washer (M6) x 5
3
to Leg F/G by aligning holes at each
Tank Support Bar with holes at the bottom of Legs.
Insert Bolt P throuth Washer Q into holes.Tighten gently with
Hex Wrench W.Then attach Tank Support Ring to the leg of
Door Panel D by aligning hole in front of Tank support Ring with
hole in Leg.
Insert Bolt P through Washer Q and then into the hole.Tighten
with Hex Wrench W
4
P
Q
Tank Access Door
Burner Control
(
controls should
face door, rotated
toward left side
of opening.
)
4