BioPress UVC 1000 /1600 / 2400 Operating instructions Notice d’emploi Instrucciones de uso
- English - REMINDER CALL 1-888-627-3435 BEFORE RETURNING TO STORE. Description Part QTY A Black hose adapter with nut and seal 2 B Transparent stepped hose adapter 2 C Flow indicator 1 D Nut 3 E Unit 1 F Hose clamp 1 A. E. C. B. D. F. Information about these operating instructions Welcome to OASE Living Water. You made a great choice with the purchase of this product BioPress UVC 1000 / 1600 / 2400.
- English - WARNINGS AND CAUTIONS SYMBOLS Symbols used in these instructions The symbols used in this operating manual have the following meanings: Risk of injury to persons due to dangerous electrical voltage. This symbol indicates an imminent danger, which can lead to death or severe injuries if the appropriate measures are not taken. ! Risk of personal injury caused by a general source of danger.
- English - Installation ! Attention! Dangerous electrical voltage. Possible consequences: Death or serious injuries. Protective measures: • Only operate the unit with the protection hood fitted. • Ensure that the unit is installed water-tight with a safety distance from the water of a minimum of 6.6 ft (2 m). Grounding instructions This appliance must be grounded.
- English - Start-up Attention! Dangerous electrical voltage. Possible consequences: Death or serious injuries. Protective measures: • Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water: Isolate the units and installations (switch off and disconnect from the power supply) before reaching into the water. • Isolate the unit before starting any work. • Secure the unit to prevent unintentional switching on.
- English - Maintenance and cleaning Attention! Dangerous electrical voltage. Possible consequences: Death or serious injuries. Protective measures: • Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water: Isolate the units and installations (switch off and disconnect from the power supply) before reaching into the water. • Isolate the unit before starting any work. • Secure the unit to prevent unintentional switching on.
- English - Maintenance and cleaning (cont.) BioPress 1600 / 2400 BioPress 1000 Full cleaning 1. Disconnect all hoses by twisting off the union nuts. 2. Open the closing clamps of the filter container. ○ BioPress 1000: Hold the filter container at the holddown element and lift off cover including the foam filter package. ○ BioPress 1600/2400: Lift off cover including foam filter package. 3. Lift off cover including foam filter package. 4.
- English - Cleaning the quartz glass / Replacing the UVC lamp ! ! Attention! Ultra-violet radiation. Possible consequences: Eye or skin injury from burns Protective measures: • Never operate the UVC lamp outside its housing. • Never operate the UVC lamp in a housing that is defective Danger: Ultraviolet radiation. Do not expose eyes to lamp rays. Disconnect power before servicing or replacing lamp.
- English - Cleaning the quartz glass / Replacing the UVC lamp (cont.) Replacing the UVC lamp Important: ● Only use lamps the identification and capacity data of which correspond to the information on the type plate. ● For an optimum filter performance, we recommend to replace the UVC lamp every year after approx. 8,000 operating hours. 5. Pull out and replace the UVC lamp. Assembly of the UVC clarifying unit 6. Insert the quartz glass including the O ring against the stop in the unit head.
- English - Storage/Winterization ● Pull out and replace the UVC lamp (Section: Replacing the UVC lamp). ● Put the unit out of operation at water temperatures below 46 °F (8 °C) or, at the latest, when freezing temperatures are to be expected. ● Drain and thoroughly clean the unit, check for damage. ● Remove, clean, dry and store all filters in a frost-free environment. ● Ensure that the storage place is inaccessible to children. ● Cover the filter container such that the ingress of rain water is excluded.