Submittal Sheet

Visit www.oatey.com for updates
TECHNICAL SPECIFICATION: Oatey H-20
95
Water Soluble Tinning Flux cleans, tins and fluxes most commonly soldered
metals including copper, brass, zinc, galvanized iron, lead and tin or copper-coated metals. Fluxing is a critical step in the
soldering process. H-20
95
Tinning Flux is lead-free and ideal for copper systems including fire sprinkler, hydronic heating,
potable water service and DWV piping. H-20
95
Tinning Flux remains active up to 700° F. H-2O
95
Flux complies with CA & VT
lead content regulations.
H-20
95
WATER SOLUBLE TINNING FLUX
PRECAUTIONS
Read all cautions and directions carefully before using this
product. Apply flux with brush- do not apply with fingers.
Wash thoroughly after handling and before eating. Eye/Skin
contact may cause intense irritation and injury. In case of
eye/skin contact, flush freely with water and seek medical
attention immediately. If swallowed, DO NOT INDUCE
VOMITING, drink water and call a physician or poison control
center immediately. Ingestion of this product could cause
gastrointestinal distress. DO NOT REUSE EMPTY
CONTAINER. KEEP OUT OF REACH OF CHILDREN.
Refer to material safety data sheet for more information.
For emergency first aid help, call 1-877-740-5015.
COMMON APPLICATIONS
Oatey H-20
95
Water Soluble Tinning Flux can be used to
solder most commonly soldered metals including copper,
brass, zinc, galvanized iron and tin or copper-coated metals.
Consult Oatey Technical Department for applications not
specifically referenced above.
INGREDIENTS (CAS Number)
Triethanolamine Hydrochloride (637-39-8)
Zinc Chloride (7646-85-7)
Ammonium Chloride (12125-02-9)
Surfactant Blend (N/A)
Inert Fillers (N/A)
Tin (7440-31-5)
Copper (7440-50-8)
Bismuth (7440-69-9)
COMPLIANCE AND LISTINGS
NSF Listed to Lead Free Flux
Standard 61 Complies with CA & VT lead legislation
Flux Base meets ASTM Standard B 813
PRODUCT
NUMBER
DESCRIPTION PACK CARTON
WEIGHT
30140 1.7 oz. H-20
95
Water Soluble Tinning Flux 12 4 lbs.
30142 8 oz. H-20
95
Water Soluble Tinning Flux 24 16 lbs.
30143 16 oz. H-20
95
Water Soluble Tinning Flux 24 15 lbs.
53068 1.7 oz. H-20
95
Water Soluble Tinning Flux with Brush – Carded 12 2 lbs.
1/2010
PHYSICAL/CHEMICAL PROPERTIES
Appearance Greenish-Gray Paste
Shelf Life 1 year from manufacture date
pH 3-4
Solder Temp. Range 400-700 F
DIRECTIONS FOR USE
Paste Fluxes require only a small amount of flux applied
to the joint. Clean all surfaces before soldering. Apply
small amount of flux inside the fitting and outside of the
pipe. Heat to temperature required for soldering. Do not
overheat the piping. For small diameter piping, direct
the heat near the joint. For large diameter piping, move
the heat around the joint to ensure adequate solder flow
around the circumference of the joint. NOT FOR USE
WITH ALUMINUM, STAINLESS STEEL OR MAGNESIUM.
DO NOT USE ON ELECTRICAL PARTS.
When soldering process is complete, allow joint to cool
undisturbed. Remove any flux residual with a damp
cloth. Do not store H-20
95
Tinning Flux above 120° F.
C-2