SDS

Oatey Clear Cleaner
SDS US
SDS # 1400E Version #: 01 Revision date: Issue date: 27-May-2015
Page 3 of 9
or vapor. Do not touch damaged containers or spilled material unless wearing appropriate
protective clothing. Ventilate closed spaces before entering them. Local authorities should be
advised if significant spillages cannot be contained. For personal protection, see section 8 of the
SDS.
Methods and materials for
containment and cleaning up
Eliminate all ignition sources (no smoking, flares, sparks, or flames in immediate area). Take
precautionary measures against static discharge. Use only non-sparking tools. Keep
combustibles (wood, paper, oil, etc.) away from spilled material. This product is miscible in
water.
Large Spills: Stop the flow of material, if this is without risk. Use water spray to reduce vapors or
divert vapor cloud drift. Dike the spilled material, where this is possible. Cover with plastic sheet
to prevent spreading. Use a non-combustible material like vermiculite, sand or earth to soak up
the product and place into a container for later disposal. Prevent entry into waterways, sewer,
basements or confined areas. Following product recovery, flush area with water.
Small Spills: Absorb with earth, sand or other non-combustible material and transfer to
containers for later disposal. Wipe up with absorbent material (e.g. cloth, fleece). Clean surface
thoroughly to remove residual contamination.
Never return spills to original container for reuse. For waste disposal, see sect. 13 of the SDS.
Environmental precautions
Avoid discharge into drains, water courses or onto the ground.
7. Handling and storage
Precautions for safe handling
Vapors may form explosive mixtures with air. Do not handle, store or open near an open flame,
sources of heat or sources of ignition. Protect material from direct sunlight. Explosion-proof
general and local exhaust ventilation. Take precautionary measures against static discharges.
All equipment used when handling the product must be grounded. Use non-sparking tools and
explosion-proof equipment. Avoid breathing mist or vapor. Avoid contact with eyes, skin, and
clothing. Avoid prolonged exposure. Do not taste or swallow. When using, do not eat, drink or
smoke. Wear appropriate personal protective equipment. Wash hands thoroughly after handling.
Observe good industrial hygiene practices.
Conditions for safe storage,
including any incompatibilities
Store locked up. Keep away from heat, sparks and open flame. Prevent electrostatic charge
build-up by using common bonding and grounding techniques. Store in a cool, dry place out of
direct sunlight. Store in original tightly closed container. Store in a well-ventilated place. Store
away from incompatible materials (see Section 10 of the SDS).
8. Exposure controls/personal protection
Occupational exposure limits
US. OSHA Specifically Regulated Substances (29 CFR 1910.1001-1050)
Components
Type
Value FORM
Acetone (CAS 67-64-1)
PEL
2400 mg/m3
1000 ppm
Cyclohexanone (CAS 108-94-1)
PEL
200 mg/m3
50 ppm
Methyl ethyl ketone (CAS 78-93-3)
PEL
590 mg/m3
200 pp,
US. ACGIH Threshold Limit Values
Components
Type
Value FORM
Acetone (CAS 67-64-1)
STEL
TWA
750 ppm
500 ppm
Cyclohexanone (CAS 108-94-1)
STEL
50 ppm
Methyl ethyl ketone (CAS 78-93-3)
STEL
TWA
300 ppm
200 ppm
US. NIOSH: Pocket Guide to Chemical Hazards
Components
Type
Value