Instructions / Assembly
INSTRUCTION GUIDE
Oatey.com
©2023 Oatey SCS. All Rights Reserved. This information is based on data believed to be reliable but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out
of its use. The data listed falls within the normal range of product properties but should not be used to establish specication limits or used alone as the basis of design. Oatey’s liability to purchasers is
expressly limited to the terms and conditions of sale. Oatey is trademark of Oatey Co. All other trademarks can be found www.Oatey.com.
GARBAGE DISPOSAL TAILPIECE
3
2
1
4
5
6
7
Measure and cut the tailpiece to the desired length.
Deburr the tube end.
Remove the screw and ange from the garbage disposal
waste connection.
Insert the garbage disposal gasket into the ange end of
the tailpiece.
Slide the ange from the garbage disposal over the tailpiece.
Insert the anged end of the tailpiece into the body of the garbage disposal. Tighten the two
screws to secure the ange and tailpiece to the garbage disposal.
Connect the P-trap to tube end.
Check for leaks. If leaks occur, tighten another ¼ turn.