Installation Guide

INSTRUCTION GUIDE
Oatey.com
©2023 Oatey SCS. All Rights Reserved. This information is based on data believed to be reliable but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out
of its use. The data listed falls within the normal range of product properties but should not be used to establish specification limits or used alone as the basis of design. Oatey’s liability to purchasers is
expressly limited to the terms and conditions of sale. Oatey is trademark of Oatey Co. All other trademarks can be found www.Oatey.com.
NUTS AND WASHERS
3
2
1
4
Deburr the end of the tube, if necessary.
For a slip joint connection: Slide the nut over the tube,
then slide the washer over the tube with the beveled edge
towards the female slip joint connection. If using a 1-1/2
in. nut with a 1-1/4 in. tube, use a reducing washer to
make the transition.
For a flanged connection: Slide the nut up the tube, then
insert the flanged washer into the flange of the tailpiece.
Tighten and check for leaks. If leaks occur, tighten another ¼ turn.