Installation Guide

BATHROOM P-TRAP
INSTRUCTION GUIDE
2
3
4
5
6
1
©2021 Oatey SCS. All Rights Reserved. This information is based on data believed to be reliable but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out
of its use. The data listed falls within the normal range of product properties but should not be used to establish specication limits or used alone as the basis of design. Oatey’s liability to purchasers is
expressly limited to the terms and conditions of sale. Oatey is trademark of Oatey Co. All other trademarks can be found www.Oatey.com.
Oatey.com
Measure and cut the wall tube to the desired length.
Position the slip nuts and slip washers onto the wall tube.
Insert the wall tube into the waste connector and hand
tighten the existing waste connector slip nut.
Position the slip nut and slip washer onto the vertical tailpiece.
Place J-bend onto the wall tube and tailpiece, and hand tighten the slip nuts for alignment.
Fully tighten all slip nuts and test for leaks.