Installation Guide

3
4
1
INSTRUCTION GUIDE
©2023 Oatey SCS. All Rights Reserved. This information is based on data believed to be reliable but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out
of its use. The data listed falls within the normal range of product properties but should not be used to establish specication limits or used alone as the basis of design. Oatey’s liability to purchasers is
expressly limited to the terms and conditions of sale. Oatey is trademark of Oatey Co. All other trademarks can be found www.Oatey.com.
Oatey.com
Position nut (C) and washer (D) on tailpiece. (Use reducer washer
if tailpiece is 1-1/4 in.)
Position nut (A) on wall tube (B).
Tighten nuts. CHECK FOR LEAKS.
Slip tailpiece into J-bend (E).
2
6
5
Measure and cut wall tube (B) to required length.
P-TRAP
Insert wall tube (B) into waste connector and tighten existing nut.