FAQs
FAQs
Drains and Closet Flanges
Q How do you vent the collection barrel when hooked up to the Mystic Rain Water diverter?
A You should contact the barrel manufacturer for their recommendations.
Q Can a Backwater valve be installed vertically?
A No. The apper would remain in an open position without any backow protection.
Q Does the Backwater valve need to have routine maintenance performed?
A Yes. After every heavy rain storm it is good practice to open the access cover to make sure no debris is lodged
between the apper and body, which would not allow the apper to close. If there aren’t any storms in a 3 month
period, it is recommended that you inspect the apper to make sure that no debris from normal use is lodged or
stuck between the apper and valve body. This will ensure the valve can seat properly if a storm occurs.
Q Should I put Plumbers Putty or silicone under the shower drain ange?
A 100% silicone caulk is recommended. There are many conditions where Plumber’s Putty could cause
product failure and nished product staining.
Q Can a Saddle Tee Kit be used in a project when plumbing inspections are necessary?
A No. This product is not intended for use in any plumbing system where plumbing codes are enforced.
Q What pipes can a Mushroom Vent Cap be used on?
A Mushroom Vent Caps can be attached to any vertical sanitary vent pipe in order to keep debris from falling
into the pipe. This doesn’t apply to septic tank vents which rise vertically out of the ground and turn down.
Q Is the at side of the No-Caulk gasket facing up or down when it is put over the drain pipe?
A The at side of the gasket should be at the bottom of No-Caulk drain body, seating onto the inside lip of
the body. The beveled side of the gasket will be facing up.