User Manual

7
Remove the quick-release
plate from the ballhead by
turning the quick-release knob
counterclockwise. This loosens
the quick-release clamp, allowing
you to remove the quick-release
plate. Mount the quick-release
plate to the threaded hole on the
base of your camera. Use the
supplied hex key to tighten the
screw. The plate utilizes a 1/4″-20
screw that will fit most cameras.
Warning: Some manufacturer’s
plates do not meet our specifications
and may not lock your equipment
securely in the Oben quick-release
clamp. Please test all camera and
lens plates made by manufacturers
other than Oben to ensure
compatibility.
After mounting the quick-release
plate to your camera, ensure
that all knobs on the ballhead
are tightened, except for the
quick-release knob. Loosen the
quick-release knob by turning it
counterclockwise until it stops.
Mount the camera to the ballhead
by sliding one edge of the quick-
release plate into the ballhead
then lower the other side until the
quick-release plate is lying flat in
the quick-release clamp. Turn the
quick-release knob clockwise to
lock the plate.
oPErAtIon
4. Mount Quick-Release Plate
5. Mount Camera